THANK YOU FOR PURCHASING NRG DTF TRANSFERS

Here are your pressing and care instructions:

1. Use a lint roller to remove any lint on the t-shirt’s press area.

2. Pre-press the garment for 5-7 seconds to remove moisture.

3. Place the design on the garment and press according to “Press Settings” below. You may need to do a few test prints to find the optimal press settings for your specific equipment and environment.

4. HOT PEEL OR COLD PEEL?

a. FOR HOT PEEL FILM: DO NOT ALLOW TO GET COLD. After pressing, wait 5-10 seconds, then peel the film from one corner in one consistent motion.

b. FOR COLD PEEL FILM: WAIT UNTIL THE TRANSFER IS COOL TO THE TOUCH, then peel.

5. Post-press the garment for 5 seconds.

*NOTE: When pressing, using a teflon sheet between the press and the design produces the best results

1. Actual press settings may differ due to equipment used and environmental conditions such as room temperature and humidity.

2. Press at medium to high pressure.

1. FOR HOT PEEL:

100% Cotton: start at 230-260F for 15 seconds and adjust as necessary
Polyester Blend: 230-260F for 15 seconds and adjust as necessary
Post-press the garment for 5 seconds
Peel 3-5 seconds after pressing.

2. FOR COLD PEEL:

100% Cotton: start at 300F for 30 seconds and adjust as necessary
Polyester Blend: start at 300F for 30 seconds and adjust as necessary
Post-press the garment for 5 seconds.
Peel when transfer is cool to touch.

Instructions

THANK YOU FOR PURCHASING NRG DTF TRANSFERS

PRESSING INSTRUCTIONS

PRESS SETTINGS

CARE INSTRUCTIONS